180 864 M1

Arm, Cross Shaft (Brake)

Name: Arm, Cross Shaft (Brake) — OEM 180 864 M1
Brand: Massey Ferguson
SKU: 180 864 M1

MF 65brakes

Aftermarket Cross-References

Cross-references are a paid feature. Upgrade to see them.

Also search on

Search Amazon→Search eBay→

Search by OEM number. Results may include new, used, and aftermarket parts.

Supersession History

Part Details

OEM Number: 180 864 M1
Part Name: Arm, Cross Shaft (Brake)
Qty per Tractor: 1
Assembly: Parts Book: Brakes (Parts Book)
System: brakes
Notes: Brake cross shaft arm. Source: MF 65 Parts Book Manual page 301. needs_verification=true.

See something wrong? Help us improve this data.

AssemblyParts Book: Brakes (Parts Book) →

Used on

MF 65

Service refMF 65 service →

Specs & Torques

Factory specs for the brakes on the MF 65from a service manual covering this part's assembly.

Fastener / Measurement	Value
Brakes: Disc diameter (MF 65) Two seven-inch double-disc brakes fitted internally in inner end of rear axle bell housing.	7–7 inch
Brakes: Lining thickness (riveted to discs) Approximately 3/16 inch. Linings riveted to discs for long service life.	0.1875–0.1875 inch
Brakes: Differential carrier plate Allen head screws torque Secures carrier plate over splines of axle shaft.	10–12 ft-lbs
Brakes: Lever support bracket bolts torque Connect brake lever support bracket (with lever attached) to axle housing.	35–35 ft-lbs

Full MF 65 torque reference →

Service Procedures

R&R and adjustment procedures for the brakes on the MF 65.

Source: MF 65 Workshop Service Manual (manual id=12). MF 65 has two seven-inch double-disc brakes mechanically activated with servo action. Linings riveted to discs (~3/16 inch thick) for long service life. Each wheel braked independently via right and left pedals; interlocking latch locks pedals together for master brake; spring-loaded pawl on left pedal locks brakes engaged for parking.

MF 65 brake adjustment: jack up both rear wheels and adjust pedals independently. Pedals must both engage and release at the same time and pedal height. Adjust by screwing brake rod yoke on (or off) brake rod to change rod length. Tighten or loosen the adjusting nut on each respective brake rod. Differential carrier plate Allen head screws torque to 10-12 ft-lbs. Brake lever support bracket bolts torque to 35 ft-lbs.

All MF 65 service procedures →

Get the free MF 65 Quick Reference Card

Capacities, fluid specs, filter cross-refs, torque specs — one printable page.